This antenna is recommended nationally for those 15-20 miles from the transmitter.
It can pick up VHF 7-13 and many have reported success with those channels. If you still have VHF problems you can also put up a separate VHF antenna and combine them using a UHF/VHF signal combiner.
It is a high gain highly directional antenna at about 3 foot by 3 foot and easily installs and rotates in attics if you cannot put it 10 feet above the roof line as allowed by the FCC.
Being directional a rotor may be required.
[img]http://www.channelmaster.com/images/4228.jpg[/img]
More information at HDTV Primer
http://www.hdtvprimer.com/ANTENNAS/comparing.html
and for the lobe pattern
http://www.hdtvprimer.com/ANTENNAS/cm4228.html
ANT Channel Master: 4228 8 bay bow tie
-
Richard
- SUPER VIP!
- Posts: 2578
- Joined: Wed Sep 08, 2004 1:28 pm
- Location: Atlanta, GA
- Contact:
ANT Channel Master: 4228 8 bay bow tie
Last edited by Richard on Sun Oct 03, 2004 9:34 pm, edited 1 time in total.
-
Windowdood
- New Member
- Posts: 1
- Joined: Thu May 06, 2004 2:05 am
- Location: Pittsboro, NC
-
AHDTV Board
- Archives
- Posts: 50
- Joined: Mon Jul 26, 2004 11:41 am
- Location: Atlanta, GA
Finally, I noticed that NBC (11.1) was no longer getting high
signals.. perhaps due to it being VHF and the CM 4228 is mostly an
UHF Antenna. I read somewhere that if you have the two screens of
the antenna touching, it works great picking up VHF. So, I used
more of the nylon ties to have the two screens touching each other
at 4 points. This boosted NBC(11.1) signal from 55 to 75.
signals.. perhaps due to it being VHF and the CM 4228 is mostly an
UHF Antenna. I read somewhere that if you have the two screens of
the antenna touching, it works great picking up VHF. So, I used
more of the nylon ties to have the two screens touching each other
at 4 points. This boosted NBC(11.1) signal from 55 to 75.
-
Richard
- SUPER VIP!
- Posts: 2578
- Joined: Wed Sep 08, 2004 1:28 pm
- Location: Atlanta, GA
- Contact:
you might want to view or participate in this conversation...
tuning a corner reflector to a specific frequency
viewtopic.php?t=14686
tuning a corner reflector to a specific frequency
viewtopic.php?t=14686
-
jamesbryant0141
- New Member
- Posts: 1
- Joined: Mon Feb 07, 2011 8:10 am
-
eliwhitney
- Major Contributor

- Posts: 484
- Joined: Thu Dec 07, 2006 5:14 am
- Location: Oklahoma
jamesbryant0141
Either list your "ZIP CODE" so's we might understand what OTA Broadcasting is available to you or go to:
www.antennaweb.org ... following it's Instructions.
Many will need a "combo" Unit, such as Channel Master's #3016 / it's 'twin" in different packaging #5646 - - - mounted high atop your Ridge of the roof on an appropriate Mast Installation ... and, use un-spliced Quad RG-6 coax w. proper compression Terminals - not "crimped" - as well, for better results. {Earth ground it properly, too, of course!}
Not costly at all - - - available @ a variety of Web Stores for FAR less $$ than any locally.
eli
Either list your "ZIP CODE" so's we might understand what OTA Broadcasting is available to you or go to:
www.antennaweb.org ... following it's Instructions.
Many will need a "combo" Unit, such as Channel Master's #3016 / it's 'twin" in different packaging #5646 - - - mounted high atop your Ridge of the roof on an appropriate Mast Installation ... and, use un-spliced Quad RG-6 coax w. proper compression Terminals - not "crimped" - as well, for better results. {Earth ground it properly, too, of course!}
Not costly at all - - - available @ a variety of Web Stores for FAR less $$ than any locally.
eli
-
Roger Halstead
- Major Contributor

- Posts: 210
- Joined: Sun Feb 26, 2006 4:13 pm
Stacking bowtie arrays
As the 8 bay bow tie antenna being discussed is already an array of "stacked antennas" adding another of the same "make and model" is relatively simple (if you have the room.)
The construction of the antennas is such that the two antennas can have their back screens/reflectors right up to the ends of each other. A little additional distance might give a little more gain, but it's unlikely it'd ever be noticed.
With the two 8 bay antennas mounted either one above the other or side by side, run equal lengths of coax from the antenna to a two port combiner. That's it.
If very far from the receiver then the output of the combiner would be the place to mount a remote preamp.
The construction of the antennas is such that the two antennas can have their back screens/reflectors right up to the ends of each other. A little additional distance might give a little more gain, but it's unlikely it'd ever be noticed.
With the two 8 bay antennas mounted either one above the other or side by side, run equal lengths of coax from the antenna to a two port combiner. That's it.
If very far from the receiver then the output of the combiner would be the place to mount a remote preamp.