Mitsubishi HDTV - 1st generation using 480P/1080I Component
Posted: Sun Jul 03, 2005 2:32 pm
Models affected: 1998-2000
Symptom: DTV input will not allow YPbPr as an input option; used to
When you go into the setup menu and try to change the DTV input it will only allow RGB or off and will not switch to YPbPr. Unplug the AC power cord from the wall for 3 minutes and plug it back in. This will create a hard reset for the computer that runs the display and should allow YPbPr as an option again.
Symptom: DTV input will not allow YPbPr as an input option; used to
When you go into the setup menu and try to change the DTV input it will only allow RGB or off and will not switch to YPbPr. Unplug the AC power cord from the wall for 3 minutes and plug it back in. This will create a hard reset for the computer that runs the display and should allow YPbPr as an option again.